Arma question (again...)

[hobgoblin]

Thanks for the input, but it doesn't work on my computer. when I hit Shift F9 once more I end up here:

0049F1B1 EC IN AL,DX ; I/O command
0049F1B2 8BF5 MOV ESI,EBP
0049F1B4 2031 AND BYTE PTR DS:[ECX],DH
0049F1B6 3132 XOR DWORD PTR DS:[EDX],ESI

If I push Shift F9 once more after this,the program terminates.

make sure you have all bp removed includeing hw bps.. Also just keep restarting the program over and over.. after a while i will run. I have seen this problem with a lot of arma apps.

BTW anyone that runs winxp sp2 does the hidedebugger plugin work for you?

Originally Posted by hobgoblin

If I push Shift F9 once more after this,the program terminates.

try use Hide Debugger v1.0.1,must operate

[Kyrios]

Hi hobogoblin,

I set some custom exception. And after press Run(F9), i land here:
POP DWORD PTR DS:[EAX]
POP DWORD PTR FS:[0]
ADD ESP,4
POP EAX
XOR EDI,EDI
INC EDI
PUSHAD

Then i hit Shift+F9, land here:
POP DWORD PTR DS:[EAX]
POP DWORD PTR FS:[0]
ADD ESP,4
POP EAX
MOV ESI,EAX
AND ESI,FFFF0000
MOV EBX,0BF1
ADD EBX,EBP
CALL EBX
PUSHAD

The second hit i land here:
POP DWORD PTR DS:[EAX]
POP DWORD PTR FS:[0]
ADD ESP,4
POPAD
PUSH EAX
PUSH ECX
BSWAP EDX
NOT EDX
PUSHFD

Sorry if the second exception codes does not look similar with previous i typed. But this is the correct one. After this point, you may use the Bp command.
If your target still silently quit, Look likes you didn't hide olly very well. You should read this

http://www.woodmann.com/forum/showthread.php?t=6167

kyrios